![]() Of course if you are replacing a broken handle, then you aren't worried about scratching it, but if you were removing the door penal for other purposes (replace a speaker, door controller, lock, etc.) then you want to be careful with the trim surfaces. If you can't get enough torque to break a bolt loose with the screwdriver style, you can always use an end wrench that will fit over the hand and use it for leverage.įinally, when separating the door handle halves, there is a small slot on the bottom where you start to pry. They work better in the small openings than sockets and there are many things on MBZs that will need these. 2005 symposium in San Antonio, TX2: The unlawful killing of. Test drive Used 2005 Mercedes-Benz C 230 at home from the top dealers in your area. mercedes-benz c230 kompressor sport mpg g2-12 manual khiladi koona full movie moustapha bangoura. This can be used for many other jobs, plus the one I link to below has the "fork" that can also be used to remove the door panel clips. Find 2005 Mercedes-Benz C 230 Cars for Sale by City. Very nice job, Hand! A few things about tools: One, get a plastic wedge tool and use that as a screwdriver to pry. If you take the panel off carefully, you sould be able to see how the cable is positioned, so you will know how it sits in the clip on back side of the door release handle in case you need to re-adjust. There should be some threads on this in the search fourm as well for further information. If the handle just pulls out with no pressure, it is off the track which creates slack in the cable and it will not work to open/close your door. When you have the door panel back in place before you re-install the clips, the torx screws and covers, pull on the door release handle to make sure it opens your door correctly. If the door panel gets jostled too much, or moved too far from the door, the cable can seperate from it's intended track, but is not easliy noticable as it is on the inside of the panel. The cable is secured by a plastic clip/track that keeps it in place tightly. When you remove the door panel, make sure to have something to set it on to keep pressure off the speaker wires unless you decide to remove those too, and make sure the cable for the door release is in it's proper track and position when you re-install our your door panel or it will not open/close the door. One other note, as I found this out the hard way.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |